Chamber cleaning
. For a light cleaning, use a cotton swab dipped in 91%+ Isopropyl Alcohol (IPA) to
remove any residue as needed. Gently cleaning the gold contact points between the
chamber and base will also help avoid potential connection issues.
2. For a deep cleaning, submerge the chamber in 91%+ IPA for 20-30 minutes.
Again, do not handle or clean the chamber while still hot.
3. To remove the tether, gently pull back to dislodge the jacket from the housing rib of
the chamber. Pull back from the other ribs until the jacket comes off completely.
4. To reattach the tether, align one of the open slots on the underside with the
chambers housing rib and push down until fully seated.
5. The tether/carb cap can also be soaked for a deep cleaning. Be mindful that IPA often
causes silicone to expand but not to worry, it will shrink back to a perfect fit.
6. After soaking, allow chamber to fully dry before use. IPA is highly flammable!
7. Hold jacket firmly during insertion / removal.
8. When reinserting, align the 3 prongs on the chamber with the base. Do not force the
chamber, this can cause irreversible damage!
Base cleaning
1. Remove glass and chamber.
2. Gently clean the gold contact points and air path of the base using a cotton swab
dipped in IPA.
3. Do not flood or soak the base with IPA.
4. Keep the USB port dry and free of IPA, water or dust.
5. Make sure that the base is completely seated inside the glass/attachment when
reinstalling for optimal sealing.
Glass cleaning
1. Carefully remove glass from base and submerge the glass in isopropyl alcohol.
2. Avoid using any other cleaning solutions or abrasive materials to clean the glass –
soaking will be sufficient.
3. After soaking, rinse clean with water. Make sure it’s thoroughly rinsed prior to use.
4. Allow glass to fully dry before reattaching to base.
5. Be careful not to slide glass to avoid scratching – use our Puffco Proxy Travel pack
for support.
How often should I clean the Puffco proxy
A good rule of thumb is to thoroughly clean the Proxy each time the battery fully
depletes and needs to be recharged. The chamber itself should be soaked in IPA
anytime you notice excess flooding or get a red/white flashing from the device.
What is the best cleaning solution for Puffco Proxy
• The only cleaning solution recommended for Puffco products is 91%+ IPA.
• Avoid using any other cleaning solutions to maintain your Puffco.
Painted glass coating on the Puffco Proxy
The Proxy painted glass coating has been designed with your complete safety
in mind. The coating was tested and complies with the required limits of ISO
10993-5:2009 for In Vitro Cytotoxicity and ISO 10993-10:2010 for Irritation and Skin
Sensitization. These are the FDA-recommended tests for a medical device with
limited contact duration with intact skin or mucosal membranes (surface device)
Get in touch with Mi-One® Brands
Customer Service Hours:
Mon - Fri 8AM - 5PM (AZT)
Email us at support@mipod.com
Call us at 1-800-768-9982
Comments
0 comments